PowerTec 71539 Instruction Sheet

INSTRUCTION SHEET
71539 Drill Press Table 14" x 24" with
Fence System
QUESTION...
1•847•780•6120
WARNING
This product is to be used with a drill press. Before using this
product, always read, understand and follow the instructions
and safety warnings in the owner's manual for the drill press. If
you do not have the owner's manual, obtain one from the tool's
manufacturer before using it with this product.
You must be familiar with the use of any tool or accessory used
with this drill press table/fence system. The supplier cannot be
held responsible for any accident, injury or damage incurred
while using this drill press table/fence system with any tool.
It is the responsibility of the purchaser of this product to ensure
that any person using this product reads and complies with all
instructions and safety precautions outlined in this manual and
the operating manual of the tool being used prior to use.
CAUTION
Do not modify or use this drill press table/fence system for any
application other than that for which it was designed.
WARNING
• To avoid serious injury, turn off and unplug the drill press
before attaching, adjusting or changing accessories.
CAUTION
Think safety! Safety is a combination of operator common sense
and alertness at all times when tool is being used.
WARNING
Do not use the drill press table/fence system until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool being
used with this drill press table/fence system.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
PACKAGING CONTENTS
ITEM DESCRIPTION
A Multi T-Track Fence
B
Table
C
Removable/adjustable Insert
D Adjustment Screws (Table Insert)
E 71083 POWERTEC T-Track
Hold-Down Clamp
F
71367 POWERTEC 3" Fence Flip Stop
G L-Shaped Multi T-Track Brackets
Figure 1
A
B
E
ASSEMBLY
Table Insert
Refer to Figure 2–3
1. There is an opening in the table for the insert, thread the
four adjustment screws into the recessed area of this
opening as shown in Figure 2.
Figure 2
Adjustment Screws
Adjustment Screws
G
F
C
D
21_0303
QTY
1
1
1
4
4
1
2