Download Print this page

Carlo De Giorgi JT-29 Instructions

For your safety, please read this manual before use and keep it for future reference.

NOTE SECURITY:

1) Do not touch, insert or remove the power cord with wet hands:

2) Do not use damaged plugs or loose outlets.

3) This product is equipped with electronic protection circuit.

4) Do not block ventilation openings in the bottom of the product.

5) Do not clean when the power is on.

6) Disconnect the power immediately in the event, during use, feel the noise and / or suspicious

smells coming from the apparatus

7) Disconnect the power to the unit when not in use and during thunderstorms.

8) In case of malfunction please contact Carlo De Giorgi srl and describe the problem in detail

Service Technicians, do not open and do not try to repair the unit.

9) The product is suitable for indoor use only.

10) Do not use if the voltage is below 198 volts or above 242 volts, the unit may be damaged

and /or malfunctions.

Voltaggio: 220Volt +/-10%

Frequenza: 50Hz

Potenza: 130W

Isolamento: apparecchio di Classe II

Instructions

P. 1 di 2

Art. 213/00 Bunsen induction

Table of Contents

Do you have a question about the JT-29 and is the answer not in the manual?

Page 1 7) Disconnect the power to the unit when not in use and during thunderstorms. 8) In case of malfunction please contact Carlo De Giorgi srl and describe the problem in detail Service Technicians, do not open and do not try to repair the unit.
Page 2 BRIEF INTRODUCTION: The product operates at high frequency and alternating magnetic fields. The metal tool for modeling the wax will be warmed through turbulence of magnetic fields created within the inductive coil. The device has a high precision control managed by microprocessor and is equipped with a sophisticated automatic protection.