dol sensors iDOL 65 Manual
Hide thumbs
Also See for iDOL 65:
- Technical user manual (8 pages) ,
- Technical user manual (4 pages) ,
- Manual (13 pages)
Table of Contents
Related Manuals for dol sensors iDOL 65
Summary of Contents for dol sensors iDOL 65
- Page 1 65 Camera For other language variants of this document we refer to www.dol-sensors.com your local dealer. dol-sensors a/s – Agro Food Park 15 – DK-8200 Aarhus N – T: +45 7217 5888 – F: +45 7217 5959 – www.dol-sensors.com...
-
Page 2: Product Description
Make sure to read the full guide before you start mounting the iDOL 65. • Make sure that the pen where the iDOL 65 is installed is empty until the camera is ready for use. • Unbox and install the iDOL 65 as described in this manual This includes mounting, electrical installation and registration of location •... - Page 3 Table 1: Demands for correct iDOL 65 mounting. Make sure that no pipes, wires, etc. are occluding (blocking) the view. The mounting should be done in a manner that minimizes any movement and vibrations. Direct sunlight into the pen should be avoided.
-
Page 4: Electrical Connection
The iDOL 65 is equipped with two Ethernet ports LAN 1 and LAN 2, meaning that the iDOL 65 can be con- nected in series. This means that the network from one iDOL 65 can be forwarded to the next. LAN 1 is used in direction towards the router and LAN 2 to the subsequent iDOL 65 in the series. - Page 5 65 requires a stable connection with a minimum bandwidth of 1Mbit/sec. Download and 0.5Mbit/sec. up- load. The network (connection to internet) must allow for: • A dynamically allocated IP for IDOL 65 (DHCP) • TCP I/O access to port 8883 (secure MQTT) •...
- Page 6 • When the iDOL 65 for registration is selected, enter the DEVICE ID found on the label inside the iDOL 65 box. • Then enter the KEY shown on the label. • Press Save. To the left: the screen where the iDOL 65 is searched for and found. To the right: iDOL 65 selected for setup. www.dol-sensors.com iDOL 65 Camera...
-
Page 7: Calibrate The Camera
Product label on the outside of the iDOL 65 box also shows the key for registration. 6.3 Calibrate the camera • Press CALIBRATE DEVICE Duration of the calibration is approx. 5 min. When the calibration is successfully completed, the camera enters the operational state. - Page 8 LAN 1 / LAN 2 LED is ON/flashes when there is an active connection though the network to another unit, for ex- ample, an iDOL 65 or a router. For further information about troubleshooting, see the DOL Omni User Guide. The iDOL 65 and DOL Omni Cloud generate error messages to the administrative personnel if the iDOL 65 stops working.
-
Page 9: Maintenance
The iDOL 65 itself does not need maintenance, but must be cleaned regularly as dust and excrements from flies etc. might block the sight of the camera and hinder heat produced by the iDOL 65 to be led away. Clean the iDOL 65 with water added a little dishwashing liquid and a soft brush or cloth. Do not use: •... - Page 10 65 Camera...
- Page 11 65 Camera...
- Page 12 dol-sensors a/s – Agro Food Park 15 – DK-8200 Aarhus N – T: +45 7217 5888 – F: +45 7217 5959 – www.dol-sensors.com...
Need help?
Do you have a question about the iDOL 65 and is the answer not in the manual?
Questions and answers