Table of Contents
Advertisement
Quick Links
Radex 1
Radex 2
&
Operator's Manual
This manual must be read
and the requirements carried out
to ensure satisfactory performance.
DICKINSON RESERVES THE RIGHT TO MAKE CHANGES TO PRODUCTS OR DOCUMENTS AT
ANY TIME
TH
QUALITY INSPECTED BY- Doug & Don AUG. 26
2011
www.dickinsonmarine.com
~
info@dickinsonmarine.com
Form# 7.2-63 (2)
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dickinson Radex 1
Summary of Contents for Dickinson Radex 1
- Page 1 Operator’s Manual This manual must be read and the requirements carried out to ensure satisfactory performance. DICKINSON RESERVES THE RIGHT TO MAKE CHANGES TO PRODUCTS OR DOCUMENTS AT ANY TIME QUALITY INSPECTED BY- Doug & Don AUG. 26 2011 www.dickinsonmarine.com info@dickinsonmarine.com...
-
Page 2: Warnings And Disclosures
Warnings and Disclosures FOLLOW ALL INSTALLATION AND OPERATING PROCEDURES WARNING! DO NOT MOUNT THIS HEATER IN THE BILGE AREA OR IN AN AREA THAT DRAWS AIR FROM THE BILGE. WARNING! ENGINE COOLANT OR BOILER HEATED WATER CAN CAUSE INJURY AND PAINFUL BURNS. USE CAUTION AND ENSURE ALL CLAMPS AND FITTINGS ARE TIGHT AND SECURE WARNING! ENSURE HANDS, WIRES, LOOSE CLOTHES AND OTHER OBSRUCTIONS ARE CLEAR OF THE FAN (S) IN THE HEATER BEFORE... -
Page 3: Mounting Kits
12v power is available. There are two Radex models, the Radex 1 and the larger Radex 2. Each use a very quiet, low amp draw fan to push air through the heated coil to heat a space. -
Page 4: Blower Fan
Blower Fan Your Radex is equipped with one or two low amp 12v fans. Each fan is controlled by a separate on and off switch. We suggest that a 3 amp fuse be used in the installation. www.dickinsonmarine.com info@dickinsonmarine.com Form# 7.2-63 (2) -
Page 5: Installation
Installation To make sure your unit has an adequate air supply install the Radex so there is at least 2” (5.08cm) of airspace behind the fan. Connect the circulating hot water to the pipes as shown. The outside dimension of the copper tubing is a ¾”... -
Page 6: Limited Warranty
If any part of your new product fails because of a manufacturing defect within the warranty period Dickinson offers to replace said parts free of charge, provided, however, that such parts have not been improperly repaired, altered or tampered with or subjected to misuse, abuse or exposed to corrosive conditions. This warranty, however, is limited by certain exclusions, time limits and exceptions as listed below. -
Page 7: Warranty Form
Return to: SINCE 1932 WARRANTY FORM I have read and understand the Limited Warranty and the Instruction Manual and agree to the terms and condition (please print) Date…………………………………………………………………………… Purchaser’s Name…………………………………………………………….. Address……………………………………………………………………….. ………………………………………………………………………………... Radex Model Name…… ……----------……………………………………… Serial Number………………………………………………………………… Date Of Purchase…………….……………………………………………….. Signature………………..…………………………………………………….. - Page 8 All rights reserved. No part of this manual may be reproduced without permission in writing from Dickinson Marine. Dickinson also reserves the right to modify or change without notice, any materials, applications, equipment, accessories, and/or prices. All measurements and weights are approximate.
Need help?
Do you have a question about the Radex 1 and is the answer not in the manual?
Questions and answers