Related Manuals for Wurth Elektronik 600 600
Summary of Contents for Wurth Elektronik 600 600
- Page 1 Crimp Tool Basic Information Read these instructions completely before using this tool! Crimp Tool PN: 600 600 Crimp Head PN: 600 600 601 01 Crimp Head Die Size .1" / .128" / .151" / .213"...
- Page 2 Operation Manual – Crimp Tool Crimp Steps Locate ferrule at appropriate hex size according to datasheet. Make sure ferrule is well sit in crimp head slot. Preface The Operating Instructions must always be within MISUSE MAY CAUSE PERSONAL reach of the hand crimping tool. This Crimp Sys- INJURY.
- Page 3 Crimp the ferrule manually. *click* Release the handle until last click. Application The ratchet has six steps. It automatically opens The Crimp System Tool has been developed for after the sixth step has been passed (principle optimal crimping of a large variety of connec- of compulsory completion).
- Page 4 Built in quick release (lock) For the moments that is necessary to release to crimp head. press *click* Press the silver button at lower handle, in order to release the crimp head. open Release completed. For quick release the lock: The lock will open automatically at the end of the crimping process. If the crimping process is interrupted, the handles of the tool must be pressed together a little and the lock pushed with an appropriate tool (e.g.
- Page 5 Crimp Head Assembly Insert crimp head manually. Match middle screw hole. Place. And screw. Crimp Head Replacement Unscrew. Remove screw. Slowly remove crimp head manually. www.we-online.com...
- Page 6 Warranty Service These crimp system tool are subject to thorough Before using the crimp system tool, make sure it quality control before leaving the factory. The en- is in a clean and proper operating state. Always closed general terms and conditions of warranty remove crimping residue.
Need help?
Do you have a question about the 600 600 and is the answer not in the manual?
Questions and answers