Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Florence Package Protector PORT
Summary of Contents for Florence Package Protector PORT
- Page 1 INSTALLATION GUIDE PORT Pedestal Mounted Product...
- Page 2 © 2020 Florence Corporation All rights reserved TABLE OF CONTENTS Getting To Know Your Package Protector™ PORT Hardware and Component List Tools Suggested for Installation Foundation Requirements Preparing For and Installing Your Package Protector™ PORT Install Anchors Check for Level (refer to FIGURE 1) Attach Pedestal to Cabinet Install Your Package Protector™...
- Page 3 Getting To Know Your Package Protector™ PORT Before the assembly process begins, please review the illustration below The major components that you will be working with are identified So, as you are installing your Package Protector™ PORT you will be familiar with terms that are used in this guide 17 3/4”...
- Page 4 Hardware and Component List The cabinet and pedestal are packaged separately Below is a list of components and hardware you will receive in each package • Pedestal ` Pedestal ` Template—guide to locate pedestal base anchors ` Rubber Pad—to be installed between concrete foundation and pedestal base •...
- Page 5 Foundation Requirements The Package Protector™ PORT may be installed on an existing concrete pad/foundation at least 4” thick If you are pouring new concrete, the following foundation is TABLE 1 required: WIDTH x DEPTH • Pier concrete foundation 12” x 18” x 24” deep THICKNESS (minimum size) •...
- Page 6 Check for Level (refer to FIGURE 1) Place rubber pad over anchors onto concrete pad Before attaching the pedestal to the FIGURE 1 cabinet, set the pedestal in place over anchor the rubber pad and check if level Note: If the pedestal is not level, anchor adjustment must be made washer...
- Page 7 Once the pedestal is in all the way (flush against the bottom of the cabinet), push the pedestal down until it FIGURE 4 locks into place When the two (2) alignment holes are in full view above the pedestal, it is locked in the proper alignment position (FIGURE 4) holes...
- Page 8 www MyPackageProtector com...
Need help?
Do you have a question about the Package Protector PORT and is the answer not in the manual?
Questions and answers