E-XTEQ GM DCBS Quick Start Manual

SWITCHING BETWEEN WI-FI AND PHYSICAL CONNECTION
The DCBS now has two options for connection between Remote and Trolley.
Please follow the steps below to switch between Wi-Fi and physical connection.
Turn on the Remote, select the
1
Setting Icon and press
Remote will show Ethernet icon
4
on top left as shown below
Turn on the Remote, select the
1
Setting Icon and press
If tool asks, please select
4 2.4GHz or 5GHz*
If successful, Remote will
7 display Connected!
-Ref. D2-0247-A_DCBS_PHYICAL_CONNECTION
SWITCH FROM WI-FI TO HARDWIRE
Select the Wireless Icon
2
and press
Connect the Ethernet cable to
5
Trolley and Remote as shown
SWITCH FROM HARDWIRE TO WI-FI
Select the Wireless Icon
2
and press
Select Barcode Scan or Manual
5 and follow on screen prompts**
Confirm connection by Wi-Fi symbol on top
left and battery voltage on bottom right if
8
connected to a battery
Select the OFF Icon
3
and press
NOTE:
The Trolley and Remote will now
communicate only through the physical
connection between them. To check if
the connection is working, connect to a
battery and see bottom of remote to
see if the trolley is reading voltage.
Restart of Trolley and Remote may be
required for proper physical connection.
Select the Trolley Connection
3
Icon and press
Remote will attempt to connect
with the trolley
6
NOTE:
*Not all tools will ask this, if screen does not
show, please move to step 5
**Barcode with serial number can be found on
back of trolley. If remote was previously
connected, re-entry of serial number may not
be necessary.
Restart of Trolley and Remote is required for
connection to be successful after switching
from Hardwire to Wi-Fi connection.