How To Finish Unpacking - AEG COMPETENCE 3210 BU Operating And Installation Instructions

INSTALLATION INSTRUCTIONS
·
Check that the mounting brackets are level.
They can be adjusted if necessary by using the
extra holes at the ends of the brackets. Once the
brackets are level, drill a pilot hole through the
central hole in the bracket and fit the remaining
screw.

HOW TO FINISH UNPACKING

·
Place appliance next to the space in which it will
be installed. See Fig 8.
·
Remove the appliance packing except for bottom
tray which should be left in position until the
appliance is ready to be fitted into its cabinet.
·
Ensure the owner is given these operating
instructions.
NOTE: It is imperative that the appliance is left in
the base to protect both the appliance and the
floor.
Important: Switch off at mains, miniature
circuit breaker and, if appropriate, remove
fuse before commencing any electrical
work.
Fig. 8
38