Before You Begin Installation Inspect The Galley Pot Filler Tap for any damage prior to installation. Please refer to all local plumbing and building codes prior to installation. INSTALLATION WARNING Spare parts Turn off the water supply lines. Observe all local plumbing codes.
Page 3
Before You Begin Installation Before installing, Rough-in plumbing must be completed. The position of your Pot Filler Tap should be considered prior to starting. When fully extended from the wall, the reach of the Pot Filler Tap is 24”. Choose a position on the wall that allows the Pot Filler Tap to reach the furthest cooking position (Fig.
Page 4
Rough-In Installation Step 1 Step 2 Wrap the 1/2” inlet with Teflon tape. Thread the housing onto 1/2” inlet. Note: Wrap in the direction of the threads fully 2-3 times. Rough-in should only be installed where the inlet connects on the left or right.
Page 5
Pot Filler Installation Step 1 Step 2 Remove inlet housing cover. Insert the Pot Filler trim piece into the inlet housing. Step 4 Step 3 Install Pot Filler Tap onto the trim piece with the With Pot Filler installed, secure it centering pin positioned on the top right.
Page 6
Pot Filler Usage • Pot Filler Tap turns on by rotating handle counter clockwise (Fig. 1). Fig. 1 Maintenance: Maintenance: Cartridge Replacement Outdoor Installation Allen Key Important - Your outdoor Galley Pot Filler Tap must be 1,5 (metric) winterized if temperature falls below freezing in your area. WINTERIZE YOUR GALLEY POT FILLER TAP: •...
ABOUT OUR FINISHES: The Galley Tap is made of solid stainless steel. This finish has NO PROTECTIVE COATING on it. Stainless steel is by its material nature very tarnish-resistant, but by no means tarnish or stain proof. This finish will react to it’s environment over time. Cleaners that contain bleach may cause rust.
Limited Lifetime Warranty expressed in this warranty. Whether to repair or replace the product shall be at the sole election of the Seller. In no event shall the liability of The Galley exceed the purchase price of the Tap.
Need help?
Do you have a question about the IPT-D and is the answer not in the manual?
Questions and answers