Advertisement
2
Installing the Hinge and
Cover
Parts needed for this procedure:
1
Glove box cover
1
Latch assembly
1
Thumb pull
1
Lock washer
1
Nut
1
Hinge
6
Rivets
1
Foam strip
Procedure
1.
Install the latch assembly, thumb pull, lock
washer, and nut to the glove box cover with the
latch facing up as shown in
1. Latch assembly
2. Thumb pull
2.
Install the hinge to the back of the glove box
cover using 3 rivets as shown in
Figure
1.
Figure 1
3. Lock washer
4. Nut
Figure
3.
Align the glove box cover to the glove box; using
the bottom of the hinge as a template, mark the
location of the center and outer holes on the
bottom of the dash.
4.
Using the outer and center marks made in step
3
as a template, drill 3 holes with 3/16 inch
diameters to fit the rivets.
5.
Clean any burrs from the drilled holes.
6.
Install the bottom hinge to the dash using 3
rivets as shown in
1. Rivet
g233662
7.
Remove the tape from the adhesive back of the
foam strip and adhere the strip to the border of
the glove box cover
2.
2
Figure 2
Figure
3.
Figure 3
2. Foam strip
(Figure
3).
g233663
g233684
Advertisement
