Advertisement
Pay attention to the position : the upper surface must be at 8mm
(0,3 inch) above the pcb surface (see drawing 2.0).
You may put some pieces of paper between the LCD and the pcb, to
help you holding the display on the right height.
First solder only the pins at the four corners.
Verify the height, and correct if necessary.
Then solder the remaining pins.
Be very careful, for this part is not cheap!
LCD
Fig. 2.0
9. Capacitors
C5 : 10nF / 250V
C7 : 100nF / 250V
C8 : 220nF / 100V
C9 : 470nF / 63V
10. LED.
Watch the polarity !
LD1
CATHODE
LD1: 5mm Red
Construction
11
Advertisement
