Advertisement
Quick Links
Ciara C/E King Assembly Instructions
Hardware included in side rails carton .
A
B
Φ8 MM
Φ8*30
MM
8PCS
4PCS
J
K
H=25.5
Φ8*80
CM
MM
8PCS
8PCS
1
Step#1
Align the headboard with the wings.Attach wings through Headboard finger tight, using
Wrench(I), Bolt (C) and Washer (E).
CONGRATULATIONS ON YOUR NEW BED PURCHASE
~Warning：do not move bed after final assembly as it may result in damages to floor and/or bed.~
C
D
Φ8*50
Φ6 MM
Φ8 MM
MM
12PCS
12PC
24PCS
L
M
Φ6*25
Φ6*20
MM
8PCS
8 PCS
E
F
H=15CM
4PCS
N
P
MM
8 PCS
2 PCS
G
H
4PCS
2PCS
Q
Y
2 PCS
1PC
I
1PC
Z
8PCS
Advertisement
Related Manuals for Living Spaces Ciara C King
Summary of Contents for Living Spaces Ciara C King
- Page 1 Ciara C/E King Assembly Instructions Hardware included in side rails carton . Φ8 MM Φ8*30 Φ8*50 Φ6 MM Φ8 MM H=15CM 8PCS 4PCS 12PCS 12PC 24PCS 4PCS 4PCS 2PCS H=25.5 Φ8*80 Φ6*25 Φ6*20 8PCS 8PCS 8PCS 8 PCS 8 PCS 2 PCS 2 PCS 8PCS...
- Page 2 Ciara C/E King Assembly Instructions Step#2 Screw the steel dowel (K) into the holes in front of wings. Screw the steel dowel (K) into the holes in front of footboard. Step#3 Attach side rails using Half-moon bolt (L) ,Washer (A) and Nut (Z) .Tighten/secure Nut (Z) using Wrench (Y) until snug.
- Page 3 Ciara C/E King Assembly Instructions Step#4 Using Bracket (H) to connect the wings with headboard, Tighten with Wrench (I), Bolt (B) and Washer (E). Step#5 Attach bed feet (F) to Wings and Footboard. Attach the bed feet one side at a time by gently lifting the bed and inserting the bed feet, rotate clockwise until snug.
- Page 4 Ciara C/E King Assembly Instructions Step#6 please put support cleat (P) into support cleat (Q) first, then attach the support cleats to side rails using Wrench (I), Bolt (C) and Washer (E). CONGRATULATIONS ON YOUR NEW BED PURCHASE ~Warning：do not move bed after final assembly as it may result in damages to floor and/or bed.~...
- Page 5 Ciara C/E King Assembly Instructions Step#7 Attach steel center support legs (J) to the Metal slat (G) using Wrench (I), Bolt (M) and Washer (D). Step#8 Move/place bed into final position in bedroom. Step#9 Attach steel slat support system to full length steel side support cleats(flat side facing up). Verify the metal slats are installed properly into support cleats and center support legs are perpendicular to the floor for full support.