Table of Contents
Advertisement
Frequency range : 15 Hz to 1 MHz and d.c. respectively
Note: Appropriate measures should be taken to obtain the correct value in case of non sinusoidal waveforms.
The measuring instrument is calibrated by comparing the frequency factor of
various frequencies. A calibration curve is constructed showing the deviation of
TOUCH CURRENT =
The potential at any point (TOUCH CURRENT) expressed as voltage
The part or contact of a TERMINAL is not HAZARDOUS LIVE if:
a) The open-circuit voltage should not exceed 35 V (peak) a.c. or 60 V d.c. or, if a) is not met.
b) The measurement of the TOUCH CURRENT shall be carried out in accordance with IEC 60990, with the measuring network
described in Annex D of this standard.
The TOUCH CURRENT expressed as voltages
- for a.c. :
= 35 V (peak) and
- for d.c. :
= 1.0 V
Note: The limit values of
d.c.
TOSHIBA WEB-ZEUS
/ 500 (peak value).
= 0.35 V (peak);
= 0.35 V (peak) for a.c. and
>> terms and conditions
>> privacy policy
Copyright © 1995-2011 TOSHIBA Corporation, All Rights Reserved.
with the solid line in figure F.2 of IEC 60990 at
from the ideal curve as a function of frequency.
and
does not exceed the following value:
and
, does not exceed the following values:
= 1.0 V for d.c. correspond to the values 0.7 mA (peak) a.c. and 2.0 mA
Advertisement
Table of Contents
