Hitachi CL32W35TAN Service Manual page 374

1
Press the cursor down button to select
2
3
Use up/down cursor buttons to select
4
Use right/left buttons to adjust chosen
5
Once highlighted, accept selection - when
6
...notes on Sleep Timer
This feature is used to automatically place your TV into standby mode after a set number of
minutes - use the right/left cursor buttons to set the timer between 5 and 120 minutes.
When the timer has only a minute left this will be shown on the screen as a countdown from 59
...notes on Default Zoom and Default 4:3
Various broadcast stations now transmit WSS (Wide Screen Signals) which identifies the picture
Built into your TV is software that detects these WSS and automatically switches your TV to the
correct format. However, some broadcasters do not transmit this WSS, and so your TV will not
recognise which format is being transmitted. Therefore, DEFAULT ZOOM is used to choose your
picture requirements when a Wide Screen Signal has not been sent or has not been detected - these
The DEFAULT 4:3 acts in the same manner, but only looks for a 4:3 WSS. If this is detected your TV's
...notes Auto WS Detect
Auto Wide Screen Detect, when switched ON (and there is no WSS signal) enables your TV's
software to look for the black bands at the top and bottom of the picture received (see C16:9L format,
If this is set to 'OFF', these black bands cannot be detected. Therefore the picture format will revert to
20
Press the MENU button to obtain
MAIN MENU.
FEATURES.
Once highlighted, accept selection.
option to adjust.
feature.
you turn your TV off, and the TV will
memorise your adjustments
seconds to zero, after which your TV's status will be standby.
format movies and programs are broadcast in.
choices are explained on the next page.
picture format will be in accordance with the setting in the DEFAULT 4:3 option.
page 22) and displays your picture in the format it is received in.
the setting specified in the DEFAULT ZOOM option if there is no WSS signal.