Table of Contents
Advertisement
All manuals and user guides at all-guides.com
CAUTION:
– For optimal sound performance, it is
recommended to use the supplied
speakers.
– Do not connect more than one speaker
to any one pair of + / - speaker
terminal.
– Do not connect speakers with
impedance lower than the speakers
supplied. Please refer to
SPECIFICATION section of this manual.
D Rear Surround Speakers'
Connection
Connect the black (non-marked) wires to
the black REAR SURROUND terminals and
the colored (marked) wires to the grey
REAR SURROUND terminals.
E Center Speaker
Connection
Connect the black (non-marked) wires to
the black CENTER terminal and the blue
(marked wires) to the blue CENTER
terminal.
Untitled-2
7
F Line Out Connection
H Subwoofer Out Connection
(wireless
Connect the optional active subwoofer to
ready)
the SUBWOOFER OUT terminal. The
You can connect the audio left and right
subwoofer reproduces just the low bass
LINE OUT terminals to a optional CD
sound effect (e.g. explosions, the rumble of
Recorder ANALOG IN terminals. This
spaceships, etc.). Be sure to follow the
allows you to record in an analogue format.
instructions supplied with the subwoofer.
You can also install additional optional
front active speakers away from the
I Digital Out Connection
system (e.g. in another room) to reduce the
You can record the digital sound from the
inconvenience of running long speaker
CD, through this output, on any audio
wires across rooms. You can place as many
equipment with digital input (e.g. CD
remote speakers as you like provided they
Recorder, Digital Audio Tape (DAT) deck,
operate at the same radio frequency.
Digital to Analog Converter and Digital
Connect the wireless radio frequency
Signal Processor).
transmitter to the LINE OUT terminals.
Place the active speakers at your preferred
Connect one end of the cinch cable (not
location. Be sure to follow the instructions
supplied) to the DIGITAL OUT socket and
supplied with the active speakers.
the other end to the audio equipment with
Note:
digital input.When connecting the cinch
– Availability of wireless transmitter and
cable, make sure it is fully inserted.
its peripherals are subjected to the
approval of local authorities. Please
J Adjusting the Operating
check with respective local safety or
approving authority.
Before connecting the AC power cord to a
G Connecting other
wall outlet, make sure that the voltage
equipment to your system
selector at the rear of the system is set to
You can connect the audio left and right
the local power line voltage. If not, reset
OUT terminals of a TV, VCR, Laser Disc
the selector before connecting to the wall
player, DVD player or CD Recorder to the
outlet.
AUX/CDR IN terminals at the rear of the
system.
K AC Power Supply
After all other connections have been
made, connect the AC power cord to the
system and to the wall outlet.
Inserting batteries into the
Remote Control
• Insert the batteries (Type R06 or AA)
into the remote control as shown in the
battery compartment.
• To avoid damage from possible battery
leakage, remove dead batteries or
batteries that will not be used for a long
time. For replacement, use type R06 or
AA batteries.
Voltage
(not available for all
versions)
6/8/01, 10:12 AM
PREPARATION
7
3139 116 19782
Advertisement
Table of Contents
