Table of Contents
Advertisement
0
Remove Remote from Network/Range Extender
•
Use a paper clip to PRESS the PROGRAM button on back of the remote three
(3) times quickly
Factory Reset
•
Send the Blind to its full OPEN position
•
Perform TWO consecutive 150mm TUGS, waiting 1 second between tugs.
•
(Blind will JOG, then travel up, settling about 50-100mm below the Upper Limit
Position)
•
Blind is now in tug command mode: There is a
•
10 second opportunity to enter a tug command before the blind will leave
Tug Command Mode and resume normal operation.
•
Perform 4 X 150mm TUGS, after each tug the bind returns to its starting
position, wait 1 second before performing the next tug
•
After the 4 Tugs are complete, the blind will move to the full open position
confirming a factory master reset.
Network Reset
•
Send the Blind to its full OPEN position
•
Perform TWO consecutive 150mm TUGS, waiting 1 second between tugs.
•
(Blind will JOG, then travel up, settling about 50-100mm below the Upper Limit
Position).
•
Blind is now in tug command mode: There is a
•
10 second opportunity to enter a tug command before the blind will leave
Tug Command Mode and resume normal operation.
•
Perform 3 X 150mm TUGS, after each tug the bind returns to its starting
position, wait 1 second before performing the next tug.
•
After the 3 Tugs are complete, the blind will move to the full open position
confirming a network reset.
Advertisement
Table of Contents
Need help?
Do you have a question about the Zigbee and is the answer not in the manual?