Advertisement
0
Add Roller Blind to Network
•
PRESS NETWORK button on the RANGE EXTENDER (Red LED will flash)
•
PULL DOWN on BOTTOM BAR 150-250mm, blind will JOG in response
Pair Roller Blind to Remote
•
PRESS the CHANNEL button to select the channel that will control the Blind
•
PRESS the PROGRAM button on the back of the remote
•
PRESS the UP button, blind will JOG in response
•
PULL DOWN on BOTTOM BAR 150-250mm, multiple blinds can be joined to
learn the same channel
Setting Bottom Limit
•
PRESS the DOWN button on the remote to send the blind to the default
bottom limit
•
Press and HOLD the DOWN button until the blind moves downward and JOGs
•
PULL DOWN on BOTTOM BAR 150-250mm, blind will JOG in response
•
PULL down on BOTTOM BAR to move the blind to the required bottom limit
•
Press and HOLD the DOWN button, the blind will JOG indicating learned
bottom limit
Intermediate Stops
The four intermediate stops will be automatically set, once the bottom limit is set.
Remove Blind from Remote Control
•
PRESS the UP button to send the blind to the full open position
•
Use a paper clip to PRESS the PROGRAM button on back of the remote
•
PRESS the DOWN button, blind will JOG
PULL DOWN on BOTTOM BAR 150-250mm, blind will JOG and move to the top
•
limit
Customise the Position of 20%, 40%, 60% & 80% Buttons
It is possible to custom change any of the intermediate stops. This is useful if you need
to align multiple blinds with varying drops to the same intermediate position.
To change the 40% button, follow the instructions below. You can substitute the 40%
button in the instructions below for any of the other intermediate buttons.
•
Press the 40% button to send the shade to 40%.
•
Press and HOLD the 40% button until the bind jogs
•
PULL the bottom bar 150-250mm, the blind will jog
•
Move the blind to the NEW 40% position by pulling down on the bottom bar or
by rolling up the blind by hand to the correct position.
•
Press and HOLD the 40% button until the blind jogs, indicating learned new
learned position.
Advertisement
