Dell E2222H Service Manual page 9

Take out 1pcs panel assembled module with front
bezel and function key board from the carton, and
S7
then examine the panel surface according to
inspection criteria. Turn over the panel, and then
place screen faced down for later assembling.
Move the bracket close to the panel, then use a
S8
proper tool to connect LVDS cable to the connector
of the panel.
Adjust the bracket chassis to the correct position,
then use a Philips-head screwdriver to tighten 2pcs
screws for locking the bracket with panel module.
S9
Use a Hex-head screwdriver to lock 2pcs screws for
locking the VGA connector.
(No.1~2 screw size=M3x4, Torque=5 0.5kgfxcm;
No.3~4 screw size=M3x8, Torque=6
1
5. Disassembly and Assembly Procedures
±
kgfxcm)
±0.5
2
Connect the panel lamp cable to the connector of
S10
the panel module, then fix the panel lamp cable with
1pcs aluminum foil as the picture below shown.
Connect the function key cable to the connector of
board, then tear off the 3pcs double-faced tape on
S11
the back of the back and fix the cable on the bracket
as the picture below shown.
3 4