Dell E2222H Instructions

Teardown instruction

Hide thumbs Also See for E2222H:

Download this manual

DELL E2222H Teardown Instruction

1. Remove Rear Cover Screw and Stand

Screws

Remove screws "1~6" on rear cover with

electric screwdriver

b. Torque: 12.0 +/- 0.5Kgf/cm, Phillips

screwdriver

2. Remove Rear Cover

Pry off the back cover of the machine

with the aid of the dismantling fixture, in

the sequence of "Bottom->Left/Right-

>Top"

Start

b. Remove Light Bar and Keypad Cable:

Remove acetate cloth tape marked with

"1", then remove light bar (grasp on Pin

then pull outwards to remove)

Remove Keypad cable "2"

4. Remove VGA screw

Remove screws "1~2" with electric

screwdriver

b. Torque: 12.0 +/- 0.5Kgf/cm, hex screwdriver

5. Remove Chassis Screw

Remove screws "1~2" with electric

screwdriver

b. Torque: 3.5 +/- 0.5Kgf/cm, Phillips

screwdriver

6. Remove Aluminium Foil and LVDS Cable

Remove aluminium tape then remove LVDS

cable (Pinch on clips on the sides)

Page 1 DELL E2222H Teardown Instruction 1. Remove Rear Cover Screw and Stand 4. Remove VGA screw Screws Remove screws “1~2” with electric Remove screws “1~6” on rear cover with screwdriver electric screwdriver b. Torque: 12.0 +/- 0.5Kgf/cm, hex screwdriver b. Torque: 12.0 +/- 0.5Kgf/cm, Phillips screwdriver 2.
Page 2 DELL E2222H Teardown Instruction 7. Remove PCBA 1 Remove Keypad Remove mylar (squared in red in the Remove keypad from front cover upper picture) (loosen hook circled in red first) b. Remove grounding screw “1” then locking screws marked “2~5” with electric screwdriver Torque: 5.5 +/- 0.5Kgf/cm, Phillips...
Page 3 DELL E2222H Teardown Instruction 1. Product Material Information The following substances, preparation, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU Council Directive 75/422/EEC. Capacitors / Condensers (containing PCB/PCT) Not used...