Advertisement
Table of Contents
- 1 1. Unscrew the Device: Remove 4 Screws from the Enclosure.
- 2 2. Unscrew the Cable Gland and Remove the Caps.
- 3 8. Status, Colour and Behaviour of the Diode (if the Device Is Properly Connected)
- 4 5. Place Three AA Batteries in the Device.
- 5 6. Assemble the Device and Screw It Back Together.
- Download this manual
8. Status, colour and behaviour of the diode (if the device is properly
connected):
Device is working correctly (power and memory) - single GREEN flash
Device is working incorrectly (power and memory) - single RED flash
Connecting to LoRaWAN - flashing BLUE
LoRaWAN frame sent - single WHITE flash
Confirmation from the server after receiving the frame - single
WHITE flash
Frame failed to confirm within specified timeout - single RED flash
LoRaWAN Disconnected - flashing BLUE
Connecting to BLE - flashing BLUE
Version 2 - February 2021
AgriBox
Quick Installation Guide
1. Unscrew the device: remove 4 screws from the enclosure.
2. Unscrew the cable gland and remove the caps.
3. Pull the soil moisture sensor through the cable gland. You can
connect one, two or three soil moisture sensors as required.
4
1
Advertisement
Table of Contents
Related Manuals for YOSensi AgriBox
Summary of Contents for YOSensi AgriBox
- Page 1 8. Status, colour and behaviour of the diode (if the device is properly AgriBox connected): Quick Installation Guide Device is working correctly (power and memory) - single GREEN flash Device is working incorrectly (power and memory) - single RED flash 1.
- Page 2 4. The soil moisture sensors should be connected according to the 5. Place three AA batteries in the device. markings: the sensor placed in CH1 (mark on the enclosure) should be 6. Assemble the device and screw it back together. inserted into the connectors marked „1”...
Need help?
Do you have a question about the AgriBox and is the answer not in the manual?
Questions and answers