Matco Tools UTL12A Quick Start Manual

WARNING
Study, understand and follow all instructions provided with
this product. Read these instructions carefully before
installing, operating, servicing or repairing this tool. Keep
these instructions in a safe, accessible place.
INTENDED USE OF THE TOOL
The UTL12A Ultra Thin Rechargeable Light is designed as a
hand-held portable electric powered light source which
provides direct light to work areas. Do not modify or replace
any pieces of this kit with foreign parts. Do not use these
tools outside of the designed intent. Never modify the tools
for any other purpose or use.
WARNING
Caution: To help prevent personal injury
• Use of this product can expose you to chemicals including
ethylene glycol, gasoline vapors and engine exhaust, which
are known to the State of California to cause cancer, birth
defects, or reproductive harm. For more information, visit
www.P65Warnings.ca.gov. Always wear ANSI approved
safety equipment, safety glasses and clothing when using
this product. Study, understand, and follow all instructions
provided with this product. Failure to read and follow all
warnings and operating instructions may result in
damages and serious injury or death.
• Always wear ANSI approved goggles when using this
product. (Users and Bystanders).
• Never use this tool for any application other than for
which it was designed.
• Only use accessories designed for this tool.
• Never alter or modify this tool in any way.
• Improper operation and/or maintenance of the tool,
modification of the tool, or use of the tool with accessories
not designed for it could result in serious injury or death.
• Always select the correct accessories of the correct size
and design for the job that you are attempting to perform.
• Always work in a clean, safe, well-lit, organized and
adequately equipped area.
ULTRA THIN
RECHARGEABLE LIGHT
Made in China
to Matco specifications
Page 1
1 YEAR LIMITED WARRANTY
The manufacturer warrants this product to the original user against
defective material or workmanship for a period of 1 year from the
date of purchase.
The manufacturer reserves the right to determine whether the part
or parts failed because of defective material, workmanship or other
causes. Failures caused by accident, alteration or misuse are not
covered by this warranty.
The manufacturer, at its discretion, will repair or replace product
covered under this warranty free of charge. Repairs or replacements
of products covered under this warranty are warranted for the
remainder of the original warranty period.
The manufacturer or its authorized service representatives must
perform all warranty repairs. Any repair to the product by
unauthorized service representatives voids this warranty. The rights
under this warranty are limited to the original user and may not be
transferred to subsequent owners.
The warranty is in lieu of all other warranties, expressed or implied,
including warranties of merchantability and fitness for a particular
purpose. Some states do not allow the exclusion or limitations of
incidental or consequential damages, so the above limitations may
not apply to you.
BEFORE USE
When unpacking, check the parts diagram and part number
listing on page 2 to make sure all parts are included. If any
parts are missing or damaged, please call your distributor.
PRODUCT INFORMATION:
Powerful, bright light. 400 lumen inspection light with
80 lumen top flashlight for 3 to 5 hours of use.
Durable design. Robust yet slim construction featuring
new 1-piece internal design with USB-C charging and
IP66 waterproof rating.
Adapts for full access. 1/2" thick design features two rear
magnets and a clip on a swivel base magnet with hook.
SPECIFICATIONS:
Battery: 2600mAH 3.7V Lithium-Ion
Charge time: 3 hrs
Work time: 3 hrs / 5 hrs
LED light intensity: 400LM / 230LM
Battery indicator: Green (high) / Red (low)
Magnets: 2 neodymium on back of light body,
1 on swivel base
Waterproof grade: IP 66
DO NOT DISCARD – GIVE TO USER
UTL12A
2010173-14