Page 2
As the SRC-1 is constructed of granite, it is quite heavy and caution should be used when placing or re-positioning by a single person. If needed, seek qualified assistance such as your Acora Acoustics dealer or consultant. Do not grasp the SRC-1 by the drivers or the rear port tube.
Page 3
Unpacking and Initial Placement Each Acora Acoustics loudspeaker has been inspected and packaged with pride. Please verify that both crates are in good condition and the serial numbers are consecutive. We do not suggest unpacking the SRC-1 alone. Have your dealer or consultant perform or at least assist with this process.
Page 4
Making Connections Any time you are making changes to the speaker connections to your amplifier, that amplifier should be switched OFF. Please double check all connections before turning the amplifier back on. Failing to do this could result in damage to your amplifier. The connection block on the SRC-1 will accommodate bare wire, spade lugs, or banana terminations.
Page 5
Amplifier Requirements and Power Handling While conditions vary widely, such as room size, preferred listening level, and content being listened to, these basic guidelines may be of value when mating the SRC-1s with the right amplifier for you. Remember, it is more likely to damage a speaker by using an amplifier with insufficient power required to drive the speakers to a desired volume, than it is to damage the speakers with an excess of power.
Page 6
SRC-1 Specifications Type - 2 Way Bass Reflex Woofer - 7” Sandwich Paper Cone Tweeter - 1” Soft Dome Ring Radiator Nominal impedance - 8 ohm Suggested amplifier range - 10w - 250w Sensitivity - 90.5 1w/1m Frequency Range - 29Hz - 30KHz Enclosure - High Polish Black Granite 3cm Exterior dimensions - 14”...
Page 7
Caring for your Acora Acoustics The SRC-1 granite enclosures require minimal care. We have included a small bottle of granite polish and a polishing chamois. These will restore the gloss and luster to your speakers’ enclosure, however it will cause damage your speakers’ drivers. Do NOT spray polish on the drivers, do NOT use a damp cloth of any kind on the drivers themselves.
Page 8
Please, Enjoy! Acora Acoustics -Hear The Truth- 165 Milner Ave Scarborough, ON, Canada M1S 4G7 (647) 812-3933 info@acoraacoustics.com...
Need help?
Do you have a question about the Hear The Truth SRC-1 and is the answer not in the manual?
Questions and answers