Sony BDP-S490 Operating Instructions Manual page 34

, When you connect the player to a TV
through an AV amplifier (receiver),
– if the AV amplifier (receiver) is not
compatible with the [Control for
HDMI] function, you may be unable
to control the TV from the player.
– if you change the HDMI
connection, disconnect and
reconnect the mains lead, or a power
failure occurs, try the following:
Switch the input selector of the
1
AV amplifier (receiver) so that the
picture from the player appears on
the TV screen.
HDMI] to [Off], then set [Control
for HDMI] to [On] (page 28). Refer
to the instruction manual supplied
with the AV amplifier (receiver).
The System Power-Off function does
not work (BRAVIA Sync).
, Check that [Control for HDMI] and
[HDMI:Linked to TV-off] are set to
[On] (page 28).
Others
Playback does not start from the
beginning of content.
, Press OPTIONS, and select [Play from
start].
Playback does not start from the
resume point where you last stopped
playing.
, The resume point may be cleared from
memory depending on the disc when
– you open the disc tray.
– you disconnect the USB device.
– you play other content.
– you turn off the player.
34
Set [Control for
2
The disc tray does not open and
"LOCK" or "D ON" appears on the
front panel display.
, When "LOCK" appears, the player is
locked. To cancel the Child Lock, hold
down N on the player until
"UNLCK" appears on the front panel
display (page 9).
, When "D ON" appears, contact your
Sony dealer or local authorised Sony
service facility.
The disc tray does not open and you
cannot remove the disc even after you
press Z.
, Try the following:
off, and disconnect the mains lead.
Reconnect the mains lead while
2
pressing down Z on the player.
Keep pressing down Z on the player
3
until the tray opens.
disc. When "OPEN" appears on the
5
front panel display, hold down [/1 on
the player for more than 10 seconds
until the player turns off.
"Exxxx" or "TEMP" appears on the
front panel display.
, When "Exxxx" appears, contact your
nearest Sony dealer or local authorised
Sony service facility and give the error
code.
, When "TEMP" appears, place the
player in a location with adequate
ventilation to prevent heat build-up in
the player. "TEMP" will appear for a
short time.
Turn the player
1
Remove the
4