Advertisement
Quick Links
•
Battery-powered suction pick-up tool with built-in vacuum pump
•
Max. pick-up suction capacity is 120gf
•
Antistatic material is used
Model No.
Power supply Two size AAA batteries
Pad
Conductive silicone rubber
Approx. 30,000suction (with alkaline batteries)
Battery life
Suction capacity 120gf (with padΦ10mm)
130(W)×29(H)×22(D)mm
Dimensions
43g
Weight
* Weight (w/o batteries, nozzle, pad)
Service life of battery
Pickup repetition limit
Approx, 30,000 pickup times
( With alkaline batteries )
*
1. 26 mm x 26 mm QFP is pickup for 2 seconds using a 10 mm dia pad and
then released for 1 second. This cycle is repeated cominuously unit the QFP is
no longer picked up.
*
2. This is the time perlod from the moment 26 mm x 26 mm QFP starts being
pickup using a 10 mm dia pad to the moment the QFP drops.
Name
HAKKO 394
Vacuum pick-up tool
394-01
*
1
Contents
Accessories
Unit
Bent Nozzle/1.1mm(with stopper)
Pad/5 mm
Pad/10 mm
Continuous pickup time
Approx, 15 hours
AAA alkaline battery
*
2
Advertisement
Related Manuals for Hakko Electronics 394-01
Summary of Contents for Hakko Electronics 394-01
- Page 1 Battery-powered suction pick-up tool with built-in vacuum pump • Max. pick-up suction capacity is 120gf • Antistatic material is used Model No. 394-01 Power supply Two size AAA batteries Conductive silicone rubber Approx. 30,000suction (with alkaline batteries) Battery life Suction capacity 120gf (with padΦ10mm) 130(W)×29(H)×22(D)mm...
- Page 2 Cordless suction pick-up tool Ultra-compact high powered pump eliminates need for a power cord and an air tube. Continuous suction allows easy handling of objects. Soft touch switch Pen-type body is easy to fit into your hand. Utilizes antistatic material Nozzle with a stopper ·...
- Page 3 A1164 Bent nozzle /0.4mm Chip resistors, other (OD 0.7mm) tiny components A1198 Bent nozzle Usable for 0603 /0.26mm chip (OD 0.5mm) *Only these 2 shapes are avilable for single use. Use Nozzle with Pad Nozzle Part No. A1165 A1486 Name/ Bent nozzle /1.1mm Straight nozzle /1.1mm Description...
- Page 4 Figure Pick-up 120g 6g 120g Performance Set Examples (using 392 as an example) *The pick-up performance shown above slightly differs depending on the surface of the object. With the bent nozzle accessory, 0603-size components can be suctioned. 0603-sized chip resistors are extreme micro- components that are often incorporated into devices such as mobile phones.
- Page 5 Part No. Name Specifications A1165 Bent nozzle w/ stopper, Φ1.1mm A1312 Φ5mm A1311 Φ10mm A1164 Bent nozzle Φ0.4mm A1198 Bent nozzle Φ0.26mm A1486 Straight nozzle w/ stopper, Φ1.1mm A1166 Φ3mm A1167 Φ7mm B2690 Joint w/ filter B2692 Silicone tube w/ filter...
-
Page 6: Names Of Parts
HAKKO 394 Names of Parts & Overhaul Procedure Names of Parts Overhaul procedure If the battery is running low, the suction force will decrease. Replace the batteries with new ones and then check that the suction force is sufficient. If the suction force is not recovered even after replacement of batteries, overhaul the unit according to the following procedures. - Page 7 3. Remove the battery case lid to remove the batteries and then loosen the 3 screws to open the handle. (Refer to Photo 2.) 4. Remove the joint and silicon tube from the pump. (Refer to Photo 3.) 5. Remove the filters from the silicon tube and the joint and remove dirt and dust with an air blower, etc..
- Page 8 7. Press-fit the silicon tube fully into the joint and pump to the end. (Refer to Photos 9 and 10.)
- Page 9 8. Install the joint and silicon tube into the handle. (Refer to Photos 11 and 12.) 9. Close the handle and tighten the 3 screws. (Refer to Photo 2.) • Install batteries in the handle and close the battery case lid. •...