Table of Contents
Advertisement
Quick Links
Operation Manual
SuperECO Pond Pump CET-26000
55550
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ insignific -
antly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Table of Contents
Related Manuals for SunSun SuperECO CET-26000
Summary of Contents for SunSun SuperECO CET-26000
- Page 1 Operation Manual SuperECO Pond Pump CET-26000 55550 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignific - antly.
- Page 2 The information contained in this document may alter at any time without previous notice. It is prohib- ited to copy or spread any parts of this document in any way without prior written allowance. All rights reserved. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Introduction Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli- ents take some basic safety precautions when using this device. Please read the operation in - structions carefully and make sure you have understood its content. Keep these operation instructions safe.
- Page 4 Connect the power supply of the controller. Controller operation instructions 1. On/off Plug in the device and touch to switch the pump on and off. If the device is not operated for a long time, please unplug it. 2. Flow rate adjusting Press to adjust the flow rate;...
- Page 5 6. Alarm function The pump will automatically stop working if running without water more than 30 s, then re-start after 3 s, repeating that 5 times and then power off permanently, reporting the error “ER03”; when the pump automatically stops working in case it is blocked, the display screen will show “ER02.” The pump will automatically re-start after the error will have been repaired.
- Page 6 3. Take off the rotor, clean or replace it. If the pump is not used for a long time, please take out the pump from the water, let it run in clean water for a moment, and then clean the inner part. Dry all parts before stocking and stock it at a secure place.
- Page 7 Disposal regulations EU guidelines regarding the disposal of scrap electric appliances (WEEE, 2012/19/EU) were imple- mented in the law related to electrical and electronic equipment and appliances. All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo.
Need help?
Do you have a question about the SuperECO CET-26000 and is the answer not in the manual?
Questions and answers