Bosch WAN2823BSN User Manual And Installation Instructions page 50

en Troubleshooting
Fault
Vibrations and movement of
the appliance whilst spin-
ning.
Drum does not turn, water
does not flow in.
Heavy foam build-up
High spin speed not
reached.
The spin programme does
not start.
50
Cause
Appliance is not correctly
aligned.
The appliance feet are not
fixed.
Transit bolts have not been
removed.
Load detection is active.
Detergent dosage is too
high.
A low spin speed is selected.
Unbalance load detection
system is using a reduced
spin speed to eliminate an
unbalance.
Drain pipe or water outlet
hose is blocked.
Drain pipe or water drain
hose is caught or jammed.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Troubleshooting
Aligning the appliance
▶
Secure the appliance feet. Aligning
▶
the appliance
Removing the transit bolts
▶
Not a fault – no action required.
▶
Note: The load detection can take up
to two minutes.
Immediate measure: Mix one table-
▶
spoon of fabric softener with 0.5
litres of water and pour the mixture
into the left-hand compartment (not
for outdoor clothing, sportswear or
items stuffed with down).
Reduce the amount of detergent for
▶
the next washing cycle with the
same load.
The next time you run a wash cycle,
▶
set a higher spin speed.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Spin programme.
▶
Clean the drain pipe and the water
▶
outlet hose.
Ensure that the drain pipe and wa-
▶
ter drain hose are not kinked or
trapped.
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Spin programme.
▶