Bosch WAN2823BSN User Manual And Installation Instructions page 49

Fault
The water is not draining.
Water is not flowing in. De-
tergent is not being dis-
pensed.
The spin cycle runs several
times.
The programme duration
changes during the wash
cycle.
No water is visible in the
drum.
Drum jerks after the pro-
gramme starts.
Residual water is present in
the compartment
Cause
Unapproved extension in-
stalled on the water drain
hose.
You have not pressed
The filters in the water inflow
are blocked.
The tap is turned off.
The water inlet hose is
kinked or jammed.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
The programme operation is
optimised electronically.
This may change the pro-
gramme duration.
The unbalanced load detec-
tion system eliminates an im-
balance by repeatedly redis-
tributing the laundry.
Foam detection system
switches on a rinse cycle if
foam build-up is too high.
Water is below the visible
area.
This is caused by an internal
motor test.
Insert in compartment
. blocked.
Troubleshooting
into the left-hand compartment (not
for outdoor clothing, sportswear or
items stuffed with down).
Reduce the amount of detergent for
▶
the next washing cycle with the
same load.
Remove any unapproved exten-
▶
sions from the water hose. Connect-
ing the appliance
⁠ . Press ⁠ .
▶
"Clean the filters in the water in-
▶
flow" → Page 44.
Turn on the tap.
▶
Ensure that the water inlet hose is
▶
not kinked or jammed.
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Note: When loading, where possible,
place large and small items of laundry
together in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Not a fault – no action required.
▶
Not a fault – no action required.
▶
Not a fault – no action required.
▶
→ "Cleaning the detergent drawer",
is
▶
Page 39
Troubleshooting en
49