Advertisement
Take out the cap from the fittings and place
1
the cap of the compression fitting over the
tubing. Push the end of the tubing over the
barb; make sure the tubing is a tight fit.
Slide the cap over the fitting and rotate it
clockwise until the tubing is sealed in place.
Connect the tubing and check all the
4
fittings are sealed. The loop order:
radiator > Reservoir Inlet
Cautions:
1. Before filling the system, please make
sure that each fitting as well as unused
ports are completely sealed.
2. If there is any case of leaking,
immediately turn off the power and
clean the leak
3. If there's any related electronic parts
stained on liquid coolant, make sure to
completely clean and dry the
components. And then make sure they
all work well.
Thermaltake recommends the following steps to be taken after completing your water loop setup
1. It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance
while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
2. Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
3. DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
4. Fill the reservoir to the top as it will prevent air from going into the pump
5. If necessary tilt the system slightly from side to side to bleed the air out of the loop.
6. Place some paper towels under fittings and joining points to test for leaks.
7. Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
© 2015 Thermaltake Technology Co., Ltd. All Rights Reserved.
Cutting and Attaching the Tubing
Connect the tubing and check all the
2
fittings are sealed. The loop order:
Pump Outlet > Water block
Filling the System
After switching off the power supply,
1
connect the PSU power cord and
product cables.
3
2
Use the refill bottle to fill coolant into the reservoir
3
Place your PSU outside of the case and attach it to
the pumps 4pin molex connector, turn on the power
of PSU and make the rest of the system fills up.
www.thermaltake.com
Connect the tubing and check all the
fittings are sealed. The loop order:
water black > radiator
Advertisement
