Table of Contents
Advertisement
2G Lift Dialer
DESCRIPTION
Alarm call: number of repetitions of alarm message.
The code to enable the speakerphone (3) can be sent at any time.
Alarm call: code to repeat the alarm message.
The codes: to repeat the message, to enable the speakerphone and to reset
the alarm (end alarm) must be different.
Alarm call: code to enable the speakerphone.
The codes to repeat the message, to enable the speakerphone and to reset
(end alarm) must be different.
Alarm call: code to enable the reset/end alarm.
The codes to repeat the message, to enable the speakerphone and to reset
(end alarm) must be different.
Alarm call: number of recalls in case on failed call.
The number of recalls is to be calculated on the number of rotations in the
address book. For example, if the set calls are 3 and:
- in the address book there is one number only, the calls will be 3 at maximum
- in the address book there are 3 numbers, there will be 9 calls totally
Welcome message: number of repetitions of the message and pause
between the repetitions.
The codes to enable the speakerphone: *1 or *2 or *3 or the password can
be sent at any time.
If you don't digit anything, after the message repetitions, 2G Lift Dialer trys
to contact Car1.
If r = 0 the configuration can be modified via SMS only.
Enable speakerphone in car (internal phone)
This command is to be sent during the welcome message playing, without
password.
Close speakerphone with the car and return to welcome message
Close speakerphone with the car
Alarm reset by configuration
Alarm reset during speakerphone on
Enable the answer to configuration messages via SMS.
By enabling the answer, after the configuration message, you will receive
ACK if the command is correct and it has been executed, NACK if the
command is not correct.
Microphone volume
Speaker volume
3.4
Configuration
COMMAND
3 9 3 [r] #
r:
from 1 to 30 (default 10)
9 5 * 0 4 * [d] #
d:
from 0 to 9 (default empty)
if empty, it is not possible request
the repetition of the message. In
factory setting, the message is
repeated 10 times.
9 6 * 0 4 * [d] #
d:
from 0 to 9 (default 3)
9 7 * 0 4 * [d] #
d:
from 0 to 99 (default 19)
if empty, by finishing the call, the
alam will reset.
3 9 9 * [n] #
n:
from 1 to 99 alarm calls (default 3)
0 infinite number of alarm calls
up to the reception of reset/end
alarm code.
3 9 4 [r] * [t]#
r:
from 1 to 98 repetitions (default
2)
0 n o m e s s s a g e , d i r e c t
speakerphone
99 infinite repetitions up to the
code of speakerphone activation.
t:
pause between the repetitions
from 5 to 20 seconds (default 7)
* 1 or wait = for Car1
* 2 = for Car2
* 3 = forCar3
1 0 #
Hang up
1 9 #
1 9
9 4 [r] #
r:
0 answer disabled (default 0)
1 answer enabled
4 2 1 [m] #
m: from 1 to 7 (default 5)
4 2 2 [a] #
a:
from 1 to 7 (default 5)
Advertisement
Table of Contents
