Table of Contents
Advertisement
127(
PageWriter 100 M1772A Cardiograph
5HFRUGLQJ D 0DQXDO (&*
To record a Manual ECG, perform the following steps.
1. If the cardiograph is not On, press
lights are lit as the cardiograph performs a short power-on
sequence.
2. Prepare the patient and apply the electrodes.
3. Press
until the light above the desired lead group is lit.
4. Choose the desired
sensitivity.
0DQXDO
5. Press
on the front panel.
6. Inspect the ECG as it prints.
If any of the traces consist of a dotted line, signifying leads off,
press
6WRS
and refer to "Correcting a Leads Off Condition" . If
you would like to try to improve one or more leads, press
and adjust the electrodes accordingly. After making
adjustments, press Manual to restart the recording.
The cardiograph will print the ECG continuously until you press the
6WRS
key.
If accurate ECG ST contours are required in
)LOWHU
key to activate the 0.05-150 Hz filters. See "Manual Report
Filters" for more details.
2Q6WDQGE\
&KDUW 6SHHG
(&* 6L]H
,
0DQXDO
Recording a Manual ECG
. The front panel
9 /HDGV
, and
6WRS
mode, turn off the
2-7
2
Advertisement
Table of Contents
