INSTALLATION INSTRUCTIONS VOLT Pro Connection Hub ® VAC-HUB5 Important: Please Read Before Installation This connection hub is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.
Page 3
Install Stake Determine the desired location Board for mounting the stake. Hammer the stake into the ground until flange of stake is flush to grade. To avoid damage to the stake, place a board on top of the stake while hammering. Stake Note: If the ground is hard and the stake is difficult to install,...
Page 4
INSTALLATION INSTRUCTIONS VOLT Pro Connection Hub ® VAC-HUB5 Remove Top Remove the top from the hub. Connect Wires Pigtail Terminal Block Connectors Open Supply Cables from Fixtures Lever Hub Opening Supply Cable from Transformer Put the supply cables from the transformer and the fixtures through the openings on the bottom of the hub.
Page 5
Attach Top After all wires are connected, carefully pull the extra wire out of the bottom openings of the hub. Then, place the top back onto the hub. Cable customersupport@voltlighting.com • 813.978.3700 - 5 -...
Page 6
INSTALLATION INSTRUCTIONS w w w . v o l t l i g h t i n g . c o m - 6 -...
Page 7
Help Hotline: 1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST) w w w . v o l t l i g h t i n g . c o m customersupport@voltlighting.com • 813.978.3700 - 7 -...
Need help?
Do you have a question about the VAC-HUB5 and is the answer not in the manual?
Questions and answers