If There Is A Problem - TEFAL PRINCIPIO FV2048E0 Manual

If there is a problem

PROBLEM CAUSES
Water drips from The chosen temperature is too
the holes in the low and does not allow for the
soleplate. formation of steam.
You are using steam while the iron
is not hot enough.
You are using the Shot of Steam
button too often.
There is too much steam.
You have stored the iron
horizontally, without emptying it
and without setting it to
Brown streaks You are using chemical descaling
come through the agents.
holes in the
You are not using the right type of
soleplate and
water.
stain the linen.
Fabric fibres have accumulated
in the holes of the soleplate and
are burning.
Your linen has not been rinsed
sufficiently or you have ironed a
new garment before washing it.
The soleplate is Your are ironing with an
dirty or brown inappropriate setting
and can stain the (temperature too high).
linen.
There is little or no The water tank is empty.
steam.
The anti-calc valve is dirty.
Your iron has a build-up of scale.
Your iron has been used dry for
too long.
The soleplate is You have placed your iron flat on
scratched or a metallic rest-plate or ironed
damaged. over a zip.
Steam or water
The steam control is not set to
comes out from
the iron as you
The water tank is overfilled.
finish filling the
tank.
There is not enough water in the
The spray does
water tank.
not spray.
If you have any problem or queries, please contact our Customer Relations team first for expert help
and advice:
0845 602 1454 - UK \ (01) 4751947 - Ireland or consult our website - www.tefal.co.uk
Environment protection first !
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
SOLUTIONS
Position the thermostat in the steam range
(from •• to MAX).
Wait until the thermostat light goes out.
Wait a few seconds between each use of
the button.
Reduce the steam.
Always store your iron on its heel.
.
Do not add any descaling agents to the
water in the water tank.
Perform a self-cleaning operation and
consult the section "What water to use?".
Perform the self-cleaning operation and
clean the soleplate with a damp sponge.
Vacuum the holes of the soleplate from
time to time.
Make sure that your laundry is rinsed
sufficiently so as to remove any deposits
of soap or chemical products on new
clothes.
Clean the soleplate as indicated above.
Select the appropriate setting.
Fill it.
Clean the anti-calc valve.
Clean the anti-calc valve and carry out a
self-clean.
Carry out a self-clean.
Always set your iron on its heel.
.
Check that the steam control is set to
Never overfill the water tank. Empty out
the excess.
Fill up the water tank.
11
GB
.