Table of Contents
Advertisement
1.2.1.2
DISASSEMBLY PROCEDURE
• Make sure that the power cord is pulled out from the AC wall
socket.
(1) Remove the 2 screws [ A ] on the left rear side of the set,
and then remove the rear cover bracket. [Fig.1]
(2) Remove the 2 screws [ B ] inside of the front door. [Fig.2]
* The screws attach the speaker panel.
(3) Remove the 2 screws [ D ] on the left edge of the rear
cover, and remove the 2 screws [ D ] on the right edge of
the rear cover. [Fig.2]
* The screws attach the speaker panel.
(4) Pull the speaker grill in front direction, and remove the
speaker grill. [Fig.2]
(5) Remove the connector [CN00Z] for the auto-convergence
sensor on the left side of the set, and the clamp fixing the
wire. [Fig.2]
(6) Remove the 2 screws [ A ] on the left front panel bracket,
and remove the 2 screws [ A ] on the right front panel
bracket. [Fig.2]
(7) Remove 1 screw C on the left edge of the rear cover, and
1 screw C on the right edge of the rear cover. [Fig.3]
(8) Remove 1 screw [ A ] on the left side of the rear cover, and
remove 1 screw [ A ] on the right side of the rear cover.
[Fig.3]
(9) Move the rear cover approx. 3cm in rear direction. Then,
remove the upper unit from the lower unit by lifting the
upper unit slowly. [Fig.3]
• VOID seal [ a ] attached to the left front panel bracket in
order to confirm that a person except JVC installation
workers has disassembled the set. This seal is removed
when the upper unit is removed, and the letters of "VOID"
appears in the place where the seal. [Fig.2]
• Two or more people are required to move the upper unit.
• Reflecting mirror is attached to the upper unit. So, handle
it carefully so as to protect it from shocks.
• In placing the upper unit on the ground, be careful not to
insert the connector for the auto-convergence on the
right side of the upper unit between the upper unit and
the ground.
• In placing the upper unit on the ground, be careful not to
insert dust inside the upper unit.
• Be careful not to hurt yourself because metal brackets for
attaching the front panel are on the ceiling part of the
lower unit.
(10) Cover the lower unit with the Top Sheet in order not to
insert dust in the lower unit. Top Sheet is the one used for
package. [Fig.4]
All manuals and user guides at all-guides.com
REAR COVER
A
BRACKET
Fig.1
a
D
CN00Z
B
Fig.2
A
C
Fig.3
Fig.4
AV-65WP7
A
D
SPEAKER GRILL
UPPER
UNIT
LOWER
UNIT
TOP SHEET
(No.52096)1-5
Advertisement
Table of Contents
