JVC AV-65WP74/HA Service Manual page 16

AV-65WP74
2.7.9 REAR PANEL
(1) Loosen 4 screws [ L ].
(2) Remove 4 screws [ M ].
(3) Raise slightly REAR PANEL upward.
(4) Take out the REAR PANEL.
NOTE :
• Before the rear panel is inserted into the cabinet, release
the short-circuit between the [SB] connector (1) pin and
(2) pin of the DIGITAL INPUT UNIT. (Refer to "CAUTION
AT DISASSEMBLY" on Page 14).
• After releasing the short-circuit between the [SB]
connectors, do not turn the power on until the rear panel
is inserted into the cabinet.
• Prior to starting the work, be sure to read the following
written instructions on the CAUTION LABEL attached to
the REAR PANEL.
Prior to starting the work, be sure to read the following
written instructions on the CAUTION LABEL attached to
the REAR PANEL.
UNPLUG THE POWER CORD FROM AC OUTLET BEFORE
OPEN THE REAR COVER (PANEL).
When the rear cover (panel) is removed, follow "CAUTION AT
DISASSEMBLY" procedure in the service manual before
plugging the TV's power cord into an AC outlet.
Failure to follow the procedure will result in PERMANENT
damage to some of the television features.
2.7.10 REAR COVER BRACKET
(1) Remove 2 screws [ N ].
(2) Take out the REAR COVER BRACKET.
2.7.11 REAR COVER
• Take out the SPEAKER GRILLE.
• Take out the FRONT CONTROL BOX.
• Take out the SCREEN ASS'Y.
(1) Remove 2 screws [ O ].
(2) Remove 2 screws [ P ] from front side.
(3) Slightly pull for backside to disengage of the REAR
COVER from hooks.
(4) Take out the REAR COVER.
NOTE :
• Because of the large size, at least two persons are
recommended for removal and reassemble.
1-16 (No.52096)
All manuals and user guides at all-guides.com
PARTITION
L
N
M
REAR PANEL
L
Fig.5
REAR COVER
P
O
P
Fig.6
REAR COVER
BRACKET