Smeg Classica SO6104APN Manual page 59

6. Press the start
appliance reservoir with water.
7. Touch the CONFIRM
that you have finished filling the reservoir.
The appliance starts the function using the
parameters set.
Cleaning the water circuit
• When cleaning the reservoir and the
hydraulic circuit, leave the jug on the door
open with the loading wand inside. The
appliance cyclically discharges certain
quantities of water used for cleaning.
• During this process, the overflowing of water
inside the oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
End of water circuit cleaning
8. After completion of the cleaning process the
request to drain the water is shown on the
display.
9. Clean and dry any residual water inside the
oven cavity.
Reservoir draining
10. Open the door
11. Place a jug or container on the open door.
12. Remove the loading wand from its holder.
13. Press the START
the water into the jug (or container).
14. Wait for the end of the drain flow.
When complete, the display will indicate that
the residual water removal process is complete.
It is recommended to carry out the
cleaning process of the reservoir and
the water circuit a couple of times.
91477A081/A
button to start filling the
button to confirm
button to start draining
You can also use a cleaning solution
instead of water. In this case it is
advisable to carry out at least a couple
of water rinses afterwards, following the
instructions in this chapter.
15. Touch the CONFIRM
16. Shake the loading wand in order to remove
any remaining water.
17. Place the loading wand back in its holder.
18. Remove the jug (or container).
19. Drain the water from the jug.
20. Close the door.
Sanitization
Sanitization with steam allows to remove the last
residues of descaling from the hydraulic circuit.
1. set a 70% combined steam function lasting
at least half an hour.
2. Fill the jug with clean water.
3. Open the appliance door.
4. Rest the jug on the open door.
5. Remove the loading wand from its holder.
6. Place the end of the tube at the bottom of
the jug (or container).
7. Press the start
appliance reservoir with water.
8. When finished, shake the loading wand to
remove any water residue.
9. Place the loading wand back in its holder.
10. Remove the jug (or container).
11. Close the door.
12. Touch the START
selected steam function.
13. Wait for the function to be executed until the
end.
14. At the end of the function, drain the reservoir
as described above.
15. Wait for the end of the drain flow.
16. Drain the water from the jug.
Take care: wait for the oven cavity to
cool down.
17. Open the door.
18. Wipe off any spillage of water in the oven
cavity with a cloth or sponge.
19. Close the door.
CLEANING AND MAINTENANCE - 131
button.
button to start filling the
button to start the