Advertisement
OptiXstar P612E
Quick Start
Mounting on the desktop
Mounting on the wall
It is recommended that the port be facing down to prevent other objects such as
dust from falling in for wall mounting, as shown in the following figure.
1.
2.
3.
Issue 02 (2019-12-31)
Do not stack the device when it is placed on the desktop.
Mark two positions with the same spacing as that between the two mounting
holes of the ONU using a marker on a wall.
Select a proper drill bit according to the outer diameter of the screws. Use a
hammer drill to drill the marked positions on the wall. Then clean the holes
and install two expansion bolts.
It is recommended that the screw diameter be less than or equal to 4 mm, the nut
diameter be 6 to 8 mm, and the length should not be less than 20 mm.
Use a screwdriver to fasten the screws into the expansion bolts, reserving 5
mm ends out of the wall, and mount the ONU onto the screws.
Copyright © Huawei Technologies Co., Ltd.
2 Installing the Device
3
Advertisement
