Advertisement
Quick Links
Advertisement
Summary of Contents for kowatec miniBot
- Page 1 miniBot...
- Page 2 Tools...
- Page 3 Parts 3 x AAA Battery Cable for LED and holder Legs Head Shoulders Body Motor Feet...
- Page 4 Assembling Right Shoulder Left Shoulder...
- Page 5 LEGS 2. Right Leg Front Back Back 1. Left Leg...
- Page 6 Body Back Cover Snap the top end of the leg on the inside slot of Back view the back cover...
- Page 7 Snap the legs completely into the back body cover Take the cable of the motor and insert into the hole on the back cover...
- Page 8 Repeat for left shoulder Snap the right shoulder to the body...
- Page 9 Secure the body with screws Place the front over to the body. Place the head...
- Page 10 Glue the battery holder on the back of the body. Make sure it does not touch the head. Make sure the motor cables come out from here...
- Page 11 Put double-side tape on the EV8 and place it on the short edge of the battery holder. Make sure the golden fingers are completely above the battery holder.
- Page 12 Peel off the cables...
- Page 13 Combine the red cable of the motor and the red peel-off cable together. Cut a piece of black tape and tape the cables together. Then connect the joined cable to the pin on the EV8.
- Page 14 Repeat the step with the black cable of the motor and the black peel-off cable. Then connect the joined cable to the pin on the EV8.
- Page 15 Use double-sided tape to tape the LED cable to the long edge of the battery holder and opposite side of the EV8. Use double-sided tape to tape the LED cable to long edge of the battert holder and oppisite side of the EV8.
- Page 16 Connect the power cable to the pin on the EV8. Pay attention to the color order of the cable.
- Page 17 Use double-sided tape to tape the feet. Make sure the feet are in-line.
- Page 18 Tie up all the cables.
- Page 19 Place the LEDs in the white connector. Insert the short pin of each LED together in the middle hole. Then bend the LED upward.
- Page 20 If you have a EV8-Writer, connect the Writer to the EV8. Connect the USB cable to the computer and download Then insert the batteries. the program.
- Page 21 MiniBot Controlled MiniBot Controlled by by Remote Control Remote Control...
- Page 22 Prepare the resistor as shown below.
- Page 23 Remove the battery and the LEDs. Insert the resistor as shown above.
- Page 24 Insert the IR LED next to the resistor. Insert the short pin of the IR LED in the middle hole of the white connector Bend the IR LED upward.
- Page 25 Connect the EV8-Writer to the EV8. Connect the USB cable to the computer and download the program. Then insert the batteries.
- Page 26 MiniBot Controlled by IR LED MiniBot Controlled by IR LED www.kowatec.com robots@kowatec.com...
Need help?
Do you have a question about the miniBot and is the answer not in the manual?
Questions and answers