Connecting With A Vcr/15K Rgb/Component Equipment - Sony VPL-PX21 Operating Instructions Manual

Using USB equipment (e.g., USB mouse)
Connect the USB equipment to the USB connector on
the connector panel.
You can connect your computer to the projector via
the RGB connector, 5BNC connector or DIGITAL
RGB connector. (The example below uses the RGB
connector.)
DIGITAL
RGB RGB
Right side
5BNC
REMOTE CONTROL S
IN
RS-232C
PLUG IN POWER
OUTPUT
MONITOR AUDIO
INPUT A
DIGITAL
RGB RGB
5BNC
USB
DIGITAL RGB R/R-Y/P
R
USB
cable A
type-B
type
(sup-
plied)
Other USB
equipment
to USB to
port monitor
out
Computer
Note
Set the DIGITAL RGB/5BNC/RGB switch to the
suitable position depending on the connection.
On the USB function
When connecting the projector to a computer by
using the USB cable for the first time, the computer
recognizes the following devices automatically.
1 USB hub (general use)
2 USB human interface device (wireless mouse
function)
3 USB human interface device (projector control
function)
The computer also recognizes the device connected
to the downstream connector on the projector.
Recommended operating environment
When you use the USB function, connect your
computer as illustrated above. This application
software and the USB function can be used on a
computer loaded with Windows 98, Windows 98 SE
or Windows 2000 preinstall models.
VIDEO IN
L R
(MONO)
S VIDEO VIDEO AUDIO
INPUT B
RGB AUDIO MOUSE
RGB AUDIO MOUSE
G/Y B/B-Y/P SYNC/HD VD
B
Stereo audio
connecting
cable (not
supplied)
HD D-sub
15-pin
cable
(supplied)
to audio
out
Notes
• As the projector recognizes the USB mouse when the
computer is connected to the USB connector, do not
connect anything to the MOUSE connector.
• Your computer may not start correctly when
connected to the projector via the USB cable. In this
case, disconnect the USB cable, restart the computer,
then connect the computer to the projector using the
USB cable.
• This projector is not guaranteed for suspend, standby
mode. When you use the projector in suspend,
standby mode, disconnect the projector from the
USB port on the computer.
• Operations are not guaranteed for all the
recommended computer environments.
Connecting with a VCR/15k RGB/
Component Equipment
This section describes how to connect the projector
with a VCR, external active speakers, and 15k RGB/
component equipment.
Also refer to the instruction manuals of the equipment
to be connected.
When making connections, be sure to:
• turn off all equipment before making any
connections.
• use the proper cables for each connection.
• insert the plugs of the cables properly; plugs that are
not fully inserted often generate noise. When pulling
out a cable, be sure to pull it out from the plug, not
the cable itself.
Right side
REMOTE CONTROL S
IN
RS-232C
PLUG IN POWER
OUTPUT
MONITOR AUDIO
INPUT A
DIGITAL
RGB RGB
5BNC
USB
DIGITAL RGB R/R-Y/P
R
S-Video cable
(not supplied)
to S video
output
Active speakers
Connecting
VIDEO IN
L
R
(MONO)
S VIDEO VIDEO AUDIO
INPUT B
RGB AUDIO MOUSE
RGB AUDIO MOUSE
G/Y B/B-Y/P SYNC/HD VD
B
Audio/video
cable
(supplied)
to audio/video
outputs
VCR
17
(GB)