Table of Contents
Advertisement
sEAT PAN
fLAT wAsHER
LOcK wAsHER
ADjusTMENT
bOLT
cONNEcT bATTERy (see figs. 3 and )
cAuTION: Do not short battery termi-
nals by allowing a wrench or any other
object to contact both terminals at the
same time. before connecting battery,
remove metal bracelets, wristwatch
bands, rings, etc.
Positive terminal must be connected
first to prevent sparking from accidental
grounding.
•
Lift seat pan to raised position.
•
Remove terminal protective caps and discard.
•
If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in the Maintenance section of this
manual for charging instructions).
•
First connect RED battery cable to positive (+) terminal
with hex bolt and keps nut as shown. Tighten securely.
Slide terminal cover over terminal.
•
Connect BLACK grounding cable to negative (-) ter-
minal with remaining hex bolt and keps nut. Tighten
securely.
AssEMbLy
sEAT
sHOuLDER
bOLT
02465
fIG. 2
TERMINAL
cOvER
02604
POsITIvE (RED)
cAbLE
sEAT PAN
02602
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
wARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
TO ROLL TRAcTOR Off sKID (see Op-
eration section for location and function of
controls)
•
Press lift lever plunger and raise attachment lift lever
to its highest position.
•
Release parking brake by depressing clutch/brake
pedal.
•
Place gearshift lever in neutral (N) position.
•
Roll tractor forward off skid.
•
Remove banding holding deflector shield up against
tractor.
TO DRIvE TRAcTOR Off sKID (see Op-
eration section for location and function of
controls)
•
Be sure all the above assembly steps have been com-
pleted.
•
Check engine oil level and fill fuel tank with gasoline.
•
Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
7
DIscARD TERMINAL
PROTEcTIvE cAPs
KEPs
NuT
NEGATIvE (bLAcK)
cAbLE
fIG. 3
fIG.
HEX bOLT
LAbEL
Advertisement
Table of Contents
