Table of Contents
Advertisement
sERvIcE AND ADjusTMENTs
wARNING: TO AvOID sERIOus INjuRy, bEfORE PERfORMING ANy sERvIcE OR ADjusT-
MENTs:
•
Depress clutch/brake pedal fully and set parking brake.
•
Place gearshift lever in neutral (N) position.
•
Place attachment clutch in "DIsENGAGED" position.
•
Turn ignition key to "sTOP" and remove key.
•
Make sure the blades and all moving parts have completely stopped.
•
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact
with plug.
TRAcTOR
TO REMOvE MOwER (see fig. 1)
Mower will be easier to remove from the right side of trac-
tor.
•
Place attachment clutch in "DISENGAGED" position.
•
Move attachment lift lever forward to lower mower to
its lowest position.
•
Roll belt off engine pulley.
•
Remove small retainer spring, and remove clutch spring
off pulley bolt.
•
Remove large retainer spring, slide collar off and push
housing guide out of bracket.
•
Disconnect anti-sway bar from chassis bracket by re-
moving retainer spring.
•
Disconnect suspension arms from rear deck brackets
by removing retainer springs.
•
Disconnect front links from deck by removing retainer
springs.
•
Raise lift lever to raise suspension arms. Slide mower
out from under tractor.
sMALL RETAINER sPRING
cLuTcH sPRING
cLuTcH
sPRING
RETAINER
sPRING
ANTI-swAy
bAR
cOLLAR
HOusING
GuIDE
fLAT wAsHER
bELT KEEPER
LARGE RETAINER
sPRING
bRAcKET
IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER
DECK IS TO BE MOUNTED ON THE TRACTOR, REMOvE THE
FRONT LINKS AND HOOK THE CLUTCH SPRING INTO SQUARE
HOLE IN FRAME.
TO INsTALL MOwER (see fig. 15)
•
Raise attachment lift lever to its highest position.
•
Slide mower under tractor with deflector shield to right
side of tractor.
•
Lower lift lever to its lowest position.
•
Connect front links to mower deck and secure with
retainer springs.
•
Connect suspension arms to rear deck brackets and
secure with retainer springs.
•
Connect anti-sway bar to chassis bracket and secure
with retainer spring.
•
Push clutch cable housing guide into bracket, slide col-
lar onto guide and secure with large retainer spring.
•
Place flat washer and clutch spring on idler pulley bolt
and secure with small retainer spring.
•
Make sure belt is inside the belt keeper at the idler and
on both sides of the wire belt keeper as shown.
wIRE bELT KEEPER
susPENsION ARMs
02845
fIG. 1
19
ENGINE
PuLLEy
sQuARE HOLE
fRONT LINK
RETAINER sPRINGs
(bOTH sIDEs)
DEfLEcTOR sHIELD
Advertisement
Table of Contents
