Advertisement
NOTE: The latest version of the installation manual is on our website. Please download it and check its release date
against the date of this manual (highlighted in yellow below). Follow the instructions of the latest release date. Link to
manual -
https://spikerengineering.com/installation
Thank you for purchasing the Spiker Engineering Scangauge Mounting Bracket. Please follow this manual carefully
to ensure a quality installation and many years of reliable service.
It is the customer's responsibility to understand all of the work involved in the installation process, and to ensure
compatibility with their vehicle. No warranty is implied for the installation, and we will not be responsible for damage
to your truck, engine, or other parts, labor, personal injury, or any other damage or injury resulting from use of these
products.
Customer understands that all parts are aftermarket parts and have no OEM specifications.
If you have any questions or concerns at any point of the installation process, please contact us at
service@spikerengineering.com
Rev 7/4/2020
This manual is property of Spiker Engineering. Any unauthorized duplication or use without written permission from Spiker
Engineering violates Copyright laws.
Copyright © 2020 Spiker Engineering. All Rights Reserved.
'01-'15 Tacoma
Scangauge Mounting Bracket
Installation Instructions
before proceeding, we'll be happy to help.
Advertisement
Table of Contents
Related Manuals for Spiker Tacoma T2SG
Summary of Contents for Spiker Tacoma T2SG
- Page 1 If you have any questions or concerns at any point of the installation process, please contact us at service@spikerengineering.com before proceeding, we’ll be happy to help. Rev 7/4/2020 This manual is property of Spiker Engineering. Any unauthorized duplication or use without written permission from Spiker Engineering violates Copyright laws. Copyright © 2020 Spiker Engineering. All Rights Reserved.
- Page 2 Enjoy a beverage of your choice to celebrate! The figure below provides an overall view of the components involved in the installation, please refer to it as you go through the steps in the following sections. Copyright © 2020 Spiker Engineering. All Rights Reserved.
- Page 3 You don’t need to remove the entire handle, just the lower mounting screw. First, pry off the lower screw cover with a small flat blade screwdriver. Next, remove the factory M6 screw. You can discard the access cover and the screw after removing: Copyright © 2020 Spiker Engineering. All Rights Reserved.
- Page 4 Place the adapter plate in front of the mounting bracket, and line up the holes, making sure that the cutout in the adapter plate is on the right, as shown below. Secure the two brackets together with the bolt and nut provided. Don’t fully tighten the nut at this point, to allow adjustments. Copyright © 2020 Spiker Engineering. All Rights Reserved.
- Page 5 Connect the cable to the OBDII port under the dash (’01-04 Tacoma – right side; ’05-15 Tacoma – left side). Zip tie or tuck away any excess portion of the cable. Copyright © 2020 Spiker Engineering. All Rights Reserved.
- Page 6 If you have any questions or issues during installation, please email us at service@spikerengineering.com. Finally, please post a product review at our webpage – https://spikerengineering.com/product/scangauge-mount-01-15-tacoma#reviews Thank you again for purchasing this mount, we hope you enjoy it for many years to come! Copyright © 2020 Spiker Engineering. All Rights Reserved.
Need help?
Do you have a question about the Tacoma T2SG and is the answer not in the manual?
Questions and answers