Remove The Base Assembly For Vesa Mounting - Philips 273E1 User Manual

2. Setting up the monitor
2.3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury.
1. Place the monitor face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
2. Use a screwdriver to loosen the
screw located at the bottom of the
base, and remove the base from the
stand.
3. Remove the hinge cover from
monitor body by using your fingers.
4. Use a screwdriver to remove the
screws on the arm, and then detach
the arm/stand from the monitor.
Note
This monitor accepts a 100mm x 100mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always
contact manufacturer for wall-mount
installation.
100mm
Note
Please purchase the appropriate wall
mount; otherwise the distance between
the back-plug-in signal cable and the
wall would be too short.
* Display design may differ from those
illustrated.
9
100mm
0°
-5°
90°