Shadowspec SS-1 Quick Start Manual

Tips & Troubleshooting
The LED Light won't come on:
Charge SS-1 Controller using the Shadowspec Charger. Please note that the
SS-1 will shut down if the battery discharge below a minimum threshold; this
protects the battery from permanent damage. Please charge to revive.
Tip: The Shadowspec Mobile Application shows the battery status. (The App will not
detect the device if the battery is fully discharged.)
The Battery is charged but Light is no longer working:
Ensure the LED light is fully plugged into the SS-1 Controller.
Complete a manual switching by pushing the button on the back of the SS-1
Controller unit.
Tip: Hold the button for 10 seconds to reset the SS-1 Controller.
Mobile Application won't detect the device:
Unit is fully discharged and not in Stand-by mode.
Tip: The default factory password word Shadowspec devices are "12345678"
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
www.shadowspec.com/smart-controller
SS-1 Bluetooth
1. User Manual
(www.shadowspec.com/smart-controller for more information)
2. x1 Shadowspec™ SS-1 Bluetooth
3. x1 Shadowspec Charger Adapter with AC Lead
(Ensure correct plug type ordered for region)
SS-1 Bluetooth Controller
Shadowspec Charger Adapter
AC Power Lead for Charger
(AU / EU / US available on request)
LED Controller & Charger
®
What is in the Box
LED Controller
®
VER-001
Fig 1. Box Contents