Shadowspec SS-1 User Manual

TIPS & TROUBLESHOOTING
The LED Light won't come on:
Charge your batter using the provided Shadowspec Charger. Please note that the SS-1 will
shut down if the battery discharge below a minimum threshold; this protects the battery from
permanent damage. Please charge to revive.
Tip: The Shadowspec Mobile Application shows the battery status. (The app won't find your battery if it's
discharged.)
The Battery is charged but Light is no longer working:
Check the battery plug is attached to the SS-1 Battery.
Cycle the battery by holding the power button for 10 seconds.
Tip: Hold the button for 10 seconds to reset the SS-1 Battery.
Mobile Application won't detect the device:
Unit is fully discharged and not in Stand-by mode.
Tip: The default factory password word Shadowspec devices are "12345678"
CARE FOR USE
• Only use the Shadowspec Charger Adapter to charge the Shadowspec SS-1 Bluetooth LED Controller.
• Please charge your SS-1 Smart Battery completely before the very first time it is used.
• Do not charge the SS-1 Smart Battery whilst fitted to the umbrella. (Always use the AC powered
charger indoors and in a dry, safe environment – charge at room temperature.)
• Do not puncture the SS-1 Controller as it contains a Lithium Ion Battery. Do not store your SS-1
Controller on the umbrella when not in use.
• Your SS-1 should not be stored for long time periods when fully charged or uncharged. Optimum
long-term storage condition is between 40% -50% charged.
• Do not expose the SS-1 Controller to temperatures higher than +55 °C.
• Do not dispose of the SS-1 Controller via normal trash disposal. Please recycle responsibly.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
www.shadowspec.com/smart-battery
SS-1 Bluetooth
1. User Manual
(www.shadowspec.com/smart-battery for more information)
2. x1 Shadowspec™ SS-1 Bluetooth
3. x1 Shadowspec Charger Adapter with AC Lead
(Check you've received the correct plug adapter for your region.)
SS-1 Bluetooth Battery
Shadowspec Charger Adapter
AC Power Lead for Charger
(AU / EU / US available on request)
LED Battery & Charger
®
WHAT IS IN THE BOX
LED Battery
®
VER-001
Fig 1. Box Contents