Advertisement
Available languages
Available languages
TGDA30CX(cx).book Page 5 Thursday, May 7, 2015 10:05 AM
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {
to turn the handset on.
1
Handset:
Lift the handset and press {
2
Base unit:
Press and hold {
} for about 5 seconds.
• If all registered handsets start ringing, press {
3
Handset:
Place the handset on the base unit or charger.
• Continue the operation even when the handset display shows
"Please wait for 1 minute.".
4
With the handset still on the base unit or charger, wait until a confirmation tone sounds
and
is displayed.
Note:
• If an error tone sounds, or if
is displayed, register the handset according to the base
unit's operating instructions.
}.
} again to stop, then repeat this step.
} for few seconds
5
Advertisement
