Table of Contents
Advertisement
During installation ensure that:
The dryer is placed on a clean, level
■
and firm surface,
The mains plug can be accessed at
■
all times,
The air inlet on the dryer is kept clear
■
and there is sufficient ventilation,
The area around the dryer is kept
■
clean and
The dryer is levelled using the
■
threaded feet.
Check the alignment of the
Note:
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
If in doubt, have the appliance
Note:
connected by a specialist.
Installation and connection
Changing the side on which
the door is hinged
Proceed as follows to change
the side on which the door is hinged:
Set the programme selector to the
1.
"Off" position, disconnect the dryer
from the mains and open the door.
Remove the screws from the dryer
2.
and then remove the dryer door.
Use a T20 (Torx) screwdriver
Note:
only. Do not use any other tools to
change the side on which the door is
hinged.
en
15
Advertisement
Table of Contents
