Advertisement
Available languages
Available languages
Your computer portion of the hardware is now set-up to control the lights and
appliances in your home! To complete the hardware setup, you need to install
Modules for the devices that you wish to control.
The first time you run ActiveHome Pro it will load a file called "MYHOME.AHX".
"MYHOME.AHX" will show a graphical representation of a Lamp Module and
Appliance Module as well as a sample Macro. The Lamp Module has been named
"My Lamp" and the Appliance Module is named "My Appliance."
"My Lamp" is already set to address A1 (Housecode A, Unit Code 1 located on the
Top right corner of the "on screen" module). This should correspond to the setting of
the physical Lamp Module that you will install (may have been included or sold
separately depending on the kit you purchased).
The "My Appliance" on screen module is set to Housecode A and Unit Code 2 to
correspond to the setting of the physical Appliance Module that you will install
(sold separately).
Make sure the Address Dials on the face of the Modules are set correctly. The red
dial should be set to A on both Modules. The black dial on the Lamp Module
should be set to 1 and the black dial on the Appliance Module should be set to a
2. If they are not set correctly, you can reset the dials with a small screw-driver or
coin (anything small enough to fit the slot in the dials).
To control a lamp using the ActiveHome program, follow these steps:
Please read through these installation steps completely before you start to install a
Lamp Module (sold separately).
1.
Plug the Lamp Module into a nearby AC outlet. If this outlet is controlled by a
wall switch, make sure the wall switch is turned on.
2.
Unplug the lamp from the wall outlet and plug it into a Lamp Module (sold
separately).
3.
If you have not already done so, start your ActiveHome Pro software by
double clicking on the ActiveHome Pro icon.
4.
Using your mouse, click the switch of "My Lamp Module" as shown on your
computer screen. There may be a delay of one or two seconds from the time
you click the "on screen" module switch and when the light actually turns on.
You can also dim the lamp by moving the slide switch up and down.
Controlling an appliance is just as easy!
Please read through these installation steps completely before you start to install an
Appliance Module (sold separately).
1.
Plug the Appliance Module into a nearby AC outlet. If this outlet is controlled
by a wall switch, make sure the wall switch is turned on.
22-2-2008
5
P/N#033000=XXXXXX
Advertisement
