Table of Contents
Advertisement
If a clog prevents the normal flow of air to the motor, the thermal protector turns
the motor off automatically to allow the motor to cool in order to prevent
possible damage to the vacuum.
During this time the headlight remains on.
To correct problem, turn off and unplug vacuum, remove clogs (see page 42),
and/or clean/replace filters (see pages 28-30).
Empty dust bin if necessary (see page 32).
Wait approximately thirty (30) minutes, plug vacuum in, turn on to see if thermal
protector has reset. Thermal protector will not reset if vacuum is not turned off
even if vacuum cools down.
Motor
Protector
Protecteur
du moteur
Protector
del motor
Thermal Protector
Motor Protector
Note: Do not block motor protector.
- 18 -
Automatically opens to provide
cooling air to the motor when a clog
occurs or when dust bin needs
changing.
Motor protector may open when
using tools.
Check operation by placing hand
over end of hose.
If motor protector opens, the vacuum
will make a slightly different sound.
Advertisement
Table of Contents
