Table of Contents
Advertisement
WARNING
Disconnect the electrical supply before servicing or cleaning the unit.
Failure to do so could result in electrical shock or personal injury from
cleaner suddenly starting.
Removing and Installing Lower Plate
Two Screws
Deux vis
Dos tornillos
Lower Plate
Plaque inférieure
Base inferior
Electrical Shock or Personal Injury Hazard
Two Locking Tabs
Deux loquets de sûreté
Dos lengüetas de cierre
Before servicing any parts,
disconnect vacuum from electrical
outlet.
Always place paper under nozzle
anytime lower plate is removed to
protect floor.
Place handle in upright position and
turn vacuum over to expose lower
plate.
Release lower plate by removing two
(2) screws and pressing inward on
two (2) locking tabs.
Remove lower plate and remove any
residue that may exist in belt area.
Reinstall lower plate by hooking front
end of lower plate into slots on front
of nozzle housing.
Make sure all wires are routed
properly and not pinched.
Press lower plate until locking tabs
snap into place then replace two (2)
screws.
- 30 -
Advertisement
Table of Contents
