Installation - AEG L6FLI48S User Manual

8 www.aeg.com
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where
the low voltage equipment has no protection against mois‐
ture
Water supply pressure
Water supply
Maximum Load
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.

5. INSTALLATION

WARNING!
Refer to Safety chapters.
5.1 Unpacking
1. Open the door. Remove all the items
from the drum.
Accessories delivered
with the appliance may
vary depending on the
model.
2. Put the packaging element on the
floor behind the appliance and
carefully put it down onto its rear
side. Remove the polystyrene
protection from the bottom.
Minimum
Maximum
1)
Cotton
Maximum spin speed
IPX4
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
Cold water
8 kg
1351 rpm
CAUTION!
Do not lay washing machine
on its front.
3. Put the appliance back into an
upright position. Remove the power
supply cable and the drain hose from
the hose holders.
WARNING!
It is possible to see
water flowing from the
drain hose. This is
because the washing
machine has been
tested at the factory.
1
2